Home > News > Industry News

Industry News

Tips on Making Willow Fence


Making baskets, furniture and fencing from the branches of the willow trees really is a tradition. Ever from ancient times, a lot of people liked to use willow branches for wattle fencing and other fencing types because of the tree's flexibility and quick growth. Besides, even a novice gardener can bend the branches of a willow into a decorative Garden Label or fence. Willow trees require moist soils to grow, but some online and local garden centers carry craft-ready willow branches and pre-made willow fencing for those lacking access to the tree's branches. In this article, we will show you how to make a willow fence.

Mark 6 fence post locations with garden stakes or rocks, leaving 14 inches between them, in order to create a 6-foot length of willow fencing.

Clear the area so 2 to 3 inches of space on either side of the intended fence where is free of plants, rocks or other obstacles.

Cut 6 wooden posts 12 inches higher than the planned height of the fence. Sharpen one end of each post with the hatchet to make it easier to drive into the ground.

Pound the posts into their intended locations with the rubber mallet. Secure the post 12 inches deep in the ground.

Gather about 10 willow branches, each about 7 feet long, for each foot in height the fence will be. However, for a loosely-woven fence you may need as few as 5 branches per foot.

Weave a willow branch in and out of the posts just above ground level. Allow the ends of the branch to extend past the end posts. Then, pound the woven branch down with the rubber mallet until it touches the ground.

Weave another willow branch into the fence row above the first branch. Place the base, or wider end of the new branch above the tip, or thinner end of the first branch. Reverse the weave, that is, start it on the opposite side of the post from the first branch.

Pound the woven branch down evenly to the preferred height, which depends on how tightly or loosely you want the fence woven.

Continue to weave branches into the fence in the same way, alternating the weave of each added row by starting on the opposite side of the post from the row below it. Place the base end of each new branch above the tip end of the branch below. Pound each new branch down after it is woven into the fence.